Strip 7/16-inch of insulation from each solid-white and white-with-black-stripe wire on both sensors. Twist together the two white-with-black-stripe wires from both sensors. Twist together the two solid-white wires from both sensors. Connect the two white-with-black-stripe wires to screw terminal 3 on the motor unit.
Also to know is, how do you put a sensor on a garage door?
See your owner's manual for the type of installation needed for your garage door. Mount the receiver sensor on the side of the garage door where it is not be affected by the sun, 4-6" above the floor. Mount the sending sensor on the opposite side of the door and finger tighten the wing nuts on both sensors.
One may also ask, how do you test a garage door sensor?
- Measure the height of your garage door sensors.
- Place the box in the garage doorway, making sure the box is in front of the garage door sensors.
- Look at both the garage door sensors.
- Open the garage door and remove the crushed box.
- Clean the lenses with a soft cloth.
- Test the door with another cardboard box.
In this manner, how do you wire a garage door without a sensor?
How to Bypass Garage Door Sensors
- Step 1: Stop the Power Supply. The first rule of bypassing garage door sensors is not related to sensors.
- Step 2: Find the Sensors and Remove them. If you check the garage door, you will find that both sides of the garage door have sensors.
- Step 3: Cut the wires and Install the New Sensors.
Can you bypass garage door sensors?
If your sensors or garage door motor is blinking or your door doesn't close, it's a sign you could have faulty sensors. Luckily, you can set most automatic garage doors to a manual mode to bypass the sensors. You can also disconnect the sensors altogether, but doing this will prevent most garage doors from working.
You May Like Also